Bestarc Plasma Cutter Machine, Pilot Arc BTC500 Pro, 50A IGBT 110V/220V | APP Control,1/2" Clean Cut 3/4" Max Cut, Inverter Metal Cutter, 2T/4T Rust Removal, 1/4 NPT Fitting, for Beginners Home DIY

[Smart APP Remote Control Distance to 98 feet] Control this plasma cutter remotely via Bluetooth APP from up to 98 feet (30 meters) away. Adjust cutting current, switch modes, save your preferred settings, and use remote diagnostics to check operating conditions in real time-no need to walk back to the machine. This smart design improves flexibility and efficiency for car repairing, workshop, farm, hobbies repairing, small job projects, Home, DIY.

[Non-Touch Pilot Arc & Air Sensor] The built-in air sensor monitors air pressure and alerts you when pressure is too low or too high. Unlike basic cutters that leave you guessing, this machine features a three-color breathing status indicator and fault code display for instant troubleshooting. The high-frequency non-touch pilot arc starts cuts without direct contact, handling rusty, painted, dirty or rough metal while reducing torch sticking and electrode wear.

[Dual Voltage 110/220V IGBT Power] Advanced IGBT inverter technology delivers strong, stable 50A cutting on either 110V or 220V. Cuts steel, aluminum, copper and other conductive metals up to 3/4 inch (20 mm). Recommended capacity: 10 mm @ 35A on 110V / 50 PSI; 18 mm @ 50A on 220V / 65 PSI. Clean, dry compressed air required. Recommended circuit breaker: up to 60A @ 110V; up to 50A @ 220V.

[2T/4T with Adjustable PA/PT & Rust Removal] 2T mode is ideal for short cuts; 4T mode enables continuous cutting without holding the trigger. Adjustable PA (pilot arc) time from 3–15 seconds helps maintain the arc on expanded metal, mesh or interrupted cuts. PT post-flow 3–15 seconds cools the torch to protect consumables. The rust removal mode strips oxidation, paint and light contaminants to prep metal surfaces for welding and repair.

[Ready to Cut in 1 Minute, ANSI Certified] Pre-installed air filter and 1/4 NPT quick connector simplify setup so you can connect the air line and start cutting in under 60 seconds. Recommended air pressure: up to 65 PSI, airflow rate: 250 L/min. Built with full safety protection against over-current, over-voltage, overload and overheating. Designed to meet ANSI applicable safety standards for workshop, garage, farm and job site use. Air compressor not included.